Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Extrusion does not match Controller position
#4
You are welcome. This difference between Path Controller an Spline Controller is based on a choice done before my time at Curvy. I kinda get why this choice was done (once you look deep in the code it kinda makes sense), but I still want to get rid of that difference. Right now I am focusing on more important fixes, but maybe some time soon.
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
Reply


Messages In This Thread
RE: Extrusion does not match Controller position - by _Aka_ - 05-26-2020, 10:18 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Incorrect mesh alignment after extrusion on curved path Thinkurvy 10 19 04-17-2024, 10:57 AM
Last Post: _Aka_
  Set Volume to the Volume Controller at Runtime pako88 2 10 04-08-2024, 03:26 PM
Last Post: _Aka_
  Get position of all control points for a spline gekido 1 6 03-28-2024, 10:08 PM
Last Post: _Aka_
  Avoiding runtime GC allocations on control point position change Ell223 8 18 02-24-2024, 10:43 AM
Last Post: _Aka_

Forum Jump: