Control points close together causing mesh overlap
|
Control points close together causing mesh overlap
|
05-23-2020, 11:49 AM
Yes you can set the handles asymmetrically, whether though the API or through the editor
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Control points close together causing mesh overlap - by amccraw - 05-22-2020, 11:56 PM
RE: Control points close together causing mesh overlap - by _Aka_ - 05-23-2020, 12:11 AM
RE: Control points close together causing mesh overlap - by amccraw - 05-23-2020, 12:32 AM
RE: Control points close together causing mesh overlap - by _Aka_ - 05-23-2020, 11:49 AM
RE: Control points close together causing mesh overlap - by amccraw - 05-23-2020, 02:22 PM
RE: Control points close together causing mesh overlap - by _Aka_ - 05-23-2020, 06:08 PM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Incorrect mesh alignment after extrusion on curved path | Thinkurvy | 6 | 10 |
Less than 1 minute ago Last Post: Thinkurvy |
|
| snap to the curve created by the curvy splines segment points | ShiroeYamamoto | 3 | 11 |
04-02-2024, 02:24 PM Last Post: _Aka_ |
|
| Get position of all control points for a spline | gekido | 1 | 6 |
03-28-2024, 10:08 PM Last Post: _Aka_ |
|
| Adjust radius of generated mesh via script? | Shackman | 1 | 4 |
03-26-2024, 01:12 PM Last Post: _Aka_ |
|
