Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Control points close together causing mesh overlap
#2
Hi,
I believe this is because the Bezier handles are way too long for that segment's length. Maybe it's not visible on the spline gizmo's because the points are too close? Try displaying apprixmation points, maybe it will be visible then.
Can you please confirm that reducing the length of the bezier handles fixes the issue?
Have a nice day
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
Reply


Messages In This Thread
RE: Control points close together causing mesh overlap - by _Aka_ - 05-23-2020, 12:11 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  snap to the curve created by the curvy splines segment points ShiroeYamamoto 1 2 10 hours ago
Last Post: _Aka_
  Get position of all control points for a spline gekido 1 2 10 hours ago
Last Post: _Aka_
  Adjust radius of generated mesh via script? Shackman 1 3 03-26-2024, 01:12 PM
Last Post: _Aka_
  Avoiding runtime GC allocations on control point position change Ell223 8 18 02-24-2024, 10:43 AM
Last Post: _Aka_

Forum Jump: