10-09-2019, 04:10 PM
Hello
Sorry for the late answer.
From my understanding, you are asking two questions
1- why the cylinder is not showing up
2- if you can move like a snake through the path
Here are my answers:
1-there can be multiple possible reasons for your issue. Please check that:
+ the prefab includes all the needed splines
+ no warning displayer in the generator modules
+ no warning or errors displayed in the console
If after all that you didn't find the issue, unpack the prefab instance and place it at the root of the scene (no parent object).
2- when extruding an object, the range parameter in the extrusion module can be used to define the part of the path the extrusion should apply on
Sorry for the late answer.
From my understanding, you are asking two questions
1- why the cylinder is not showing up
2- if you can move like a snake through the path
Here are my answers:
1-there can be multiple possible reasons for your issue. Please check that:
+ the prefab includes all the needed splines
+ no warning displayer in the generator modules
+ no warning or errors displayed in the console
If after all that you didn't find the issue, unpack the prefab instance and place it at the root of the scene (no parent object).
2- when extruding an object, the range parameter in the extrusion module can be used to define the part of the path the extrusion should apply on
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.