Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Generator Shape Extrusion Range/Lenght precision
#4
(07-10-2019, 07:10 AM)UsernameHed Wrote: So TF is relative to the lenght of the Segments in the spline.
Not really. If you have 4 segments in your spline, the TF at the start of the 2nd segment is always 0.25, whatever the length of the spline's segments are.
That was just a small clarification, it doesn't change the pertinence of your solution
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
Reply


Messages In This Thread
RE: Generator Shape Extrusion Range/Lenght precision - by _Aka_ - 07-10-2019, 10:21 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
Exclamation Extending Curvy Generator for Advanced Lofting - Feasibility Check amutp 2 4 03-27-2024, 07:25 AM
Last Post: amutp
  8.8.0 is live, and it improves Curvy Generator greatly _Aka_ 0 6 03-27-2024, 03:23 AM
Last Post: _Aka_
  Generating GO only on CPs in Generator GameDeveloperek4123 1 6 03-04-2024, 11:06 AM
Last Post: _Aka_
Question Generator Canvas workflow issues Sacryn 1 7 02-02-2024, 11:22 PM
Last Post: _Aka_

Forum Jump: