Dear members of CurvySpline forum.
Is it possible to create, by code, a spline extrusion with variable width? If so, can somebody point me in the right direction? I have not been able to find a proper answer for it. I know is possible to change the overall width of the whole spline, but I wonder how could I have different width parameters using the same spline. (I would like to avoid creating different splines for each section with different width).
Thanks in advance for your time.
Kind Regards
MarioB
Is it possible to create, by code, a spline extrusion with variable width? If so, can somebody point me in the right direction? I have not been able to find a proper answer for it. I know is possible to change the overall width of the whole spline, but I wonder how could I have different width parameters using the same spline. (I would like to avoid creating different splines for each section with different width).
Thanks in advance for your time.
Kind Regards
MarioB