09-15-2013, 03:12 PM
It would also be nice to be able to snap a spline to the surface of another splines generated mesh.
For example, Create an 8 segment ngon spline mesh from a 4 nodes spline. Then create another spline with the same properties but have it spiral around the other spline, snapping the surfaces together.
You might think of something like a screw, where 1 spline is the core, and the other spline is the threads.
For example, Create an 8 segment ngon spline mesh from a 4 nodes spline. Then create another spline with the same properties but have it spiral around the other spline, snapping the surfaces together.
You might think of something like a screw, where 1 spline is the core, and the other spline is the threads.