Connection noob, all round noob in fairness
|
Connection noob, all round noob in fairness
|
08-15-2018, 12:08 AM
Hi, was hoping someone could help me out? So I am trying to connect 2 splines together, one horizontal one vertical. I have a flying creature attached with a spline controller, and when I reach the end of the horizontal spline I need it to immediately drop vertically. I am pressing connect on the end and start cp's, but the drop down doesn't see either. I am new to this and would greatly appreciate some help out of this hole
 Alan.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Connection noob, all round noob in fairness - by Alan M - 08-15-2018, 12:08 AM
RE: Connection noob, all round noob in fairness - by _Aka_ - 08-15-2018, 10:58 AM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
|
Changing spline connection in inspector causes splines to revert to defaults | lacota | 3 | 6 |
03-18-2024, 07:55 PM Last Post: _Aka_ |
|
Can't delete connection | lacota | 3 | 6 |
03-16-2024, 11:34 AM Last Post: _Aka_ |
|
Junction & Connection Navigation System Design | SAMYTHEBIGJUICY | 4 | 13 |
11-27-2023, 01:04 PM Last Post: _Aka_ |
| Connection "next' control point | jh092 | 3 | 15 |
11-22-2023, 11:47 AM Last Post: _Aka_ |
|
