Can I change splines at run-time?
|
Can I change splines at run-time?
|
01-29-2018, 08:22 AM
Let's say I have made 3 individual splines parallel to each other. An object starts on the spline in the middle and the object starts moving on the spline. If I press Left, the object should gradually move to the spline on the left and continue to move on this left spline? Is that possible?
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Can I change splines at run-time? - by DeltaMike1010 - 01-29-2018, 08:22 AM
RE: Can I change splines at run-time? - by _Aka_ - 01-29-2018, 10:57 AM
RE: Can I change splines at run-time? - by DeltaMike1010 - 01-29-2018, 11:08 AM
RE: Can I change splines at run-time? - by _Aka_ - 01-29-2018, 12:32 PM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| snap to the curve created by the curvy splines segment points | ShiroeYamamoto | 3 | 11 |
04-02-2024, 02:24 PM Last Post: _Aka_ |
|
|
Changing spline connection in inspector causes splines to revert to defaults | lacota | 3 | 6 |
03-18-2024, 07:55 PM Last Post: _Aka_ |
| Using Unity's SplineContainer in Curvy Splines | dlees9191 | 3 | 15 |
02-26-2024, 09:49 AM Last Post: _Aka_ |
|
| Avoiding runtime GC allocations on control point position change | Ell223 | 8 | 18 |
02-24-2024, 10:43 AM Last Post: _Aka_ |
|
