Curvy Splines Support Forum › Curvy Splines › Curvy Splines - support forum v
Spline Path Extrusion

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Spline Path Extrusion
Elenesski Offline
Junior Member
**
Posts: 15
Threads: 5
Joined: Oct 2015
#1
12-26-2017, 01:25 AM
Is it possible to create a 3D mesh by extruding a Spline Path into a 3D?  I can write that logic myself with curvy (which I own), I was wondering if the tool supported that out of the box?  If yes, can I morph through multiple Spline paths?

El
Find
Reply


Messages In This Thread
Spline Path Extrusion - by Elenesski - 12-26-2017, 01:25 AM
RE: Spline Path Extrusion - by Elenesski - 12-26-2017, 06:02 AM
RE: Spline Path Extrusion - by _Aka_ - 01-12-2018, 06:07 PM
RE: Spline Path Extrusion - by Elenesski - 01-17-2018, 02:45 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Incorrect mesh alignment after extrusion on curved path Thinkurvy 10 21 04-17-2024, 10:57 AM
Last Post: _Aka_
  Rasterized Path Range issue proton 2 12 04-15-2024, 03:42 PM
Last Post: _Aka_
  Curvy Line Renderer for UI Spline? gekido 3 6 04-04-2024, 12:56 PM
Last Post: _Aka_
  Get position of all control points for a spline gekido 1 6 03-28-2024, 10:08 PM
Last Post: _Aka_

Forum Jump: