Curvy Splines Support Forum › Curvy Splines › Curvy Splines - support forum v
Shape extrusion "range" changes in run time to "length"

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Shape extrusion "range" changes in run time to "length"
hawken Offline
Junior Member
**
Posts: 44
Threads: 14
Joined: Dec 2017
#3
01-15-2018, 03:15 AM
thanks!

Yes this is changing a spline from open to closed in run time.

For now I'm checking the state of the spline and if it gets closed I change these values in code to make sense again.
Find
Reply


Messages In This Thread
RE: Shape extrusion "range" changes in run time to "length" - by hawken - 01-15-2018, 03:15 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Incorrect mesh alignment after extrusion on curved path Thinkurvy 10 19 04-17-2024, 10:57 AM
Last Post: _Aka_
  Rasterized Path Range issue proton 2 10 04-15-2024, 03:42 PM
Last Post: _Aka_
  Keeping a fixed spline length jh092 3 16 02-21-2024, 06:25 AM
Last Post: Primrose44
  Curvy discards Input Spline Range VoltDriver 3 5 11-28-2023, 07:14 PM
Last Post: _Aka_

Forum Jump: