01-01-2016, 01:16 AM
I was testing curvy with a roller coaster design. I have support beams along the curve. The beams look fine when the roller coaster tracksĀ are horizontal with each other, but when I have the rails banking I can't figure out how I can get the support beams to align with the rails.
I have attached an image showing the issue. The horizontal support could be aligned by changing the volume spot rotation from horizontal to full, but I'm not sure what to do about the two vertical support beams.
I couldn't find anything in the examples or on this forum when trying to attempt something like this. What would be the best way to handle this?
I have attached an image showing the issue. The horizontal support could be aligned by changing the volume spot rotation from horizontal to full, but I'm not sure what to do about the two vertical support beams.
I couldn't find anything in the examples or on this forum when trying to attempt something like this. What would be the best way to handle this?