12-04-2025, 02:14 PM
Hi,
The solution to your issue should be to use the "Allow Direction Changes" setting in the "Connections Handling" section of your spline controller.
Did this help?
The solution to your issue should be to use the "Allow Direction Changes" setting in the "Connections Handling" section of your spline controller.
Did this help?
Available for freelance work, feel free to reach out: toolbuddy.net
Please consider leaving a review for Curvy, this helps immensely. Thank you.
Please consider leaving a review for Curvy, this helps immensely. Thank you.
