08-05-2022, 07:29 AM
Solved!!
Discovered that changing the UV offset was significantly more efficient.
Discovered that changing the UV offset was significantly more efficient.
Curvy Splines Support Forum
›
Curvy Splines
›
Curvy Splines - support forum
Efficiently chopping up a build extrusion?
Efficiently chopping up a build extrusion?
|
Efficiently chopping up a build extrusion?
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Efficiently chopping up a build extrusion? - by blabz2007 - 08-04-2022, 03:20 PM
RE: Efficiently chopping up a build extrusion? - by blabz2007 - 08-05-2022, 07:29 AM
RE: Efficiently chopping up a build extrusion? - by _Aka_ - 08-05-2022, 10:43 AM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Incorrect mesh alignment after extrusion on curved path | Thinkurvy | 10 | 21 |
04-17-2024, 10:57 AM Last Post: _Aka_ |
|
| Fading in/out extrusion mesh of a spline? | _RicO | 3 | 5 |
07-25-2023, 09:40 PM Last Post: _Aka_ |
|
| Invisible generated meshes in build | itsGama | 5 | 10 |
06-08-2023, 11:53 AM Last Post: _Aka_ |
|
| Missing Loader errors after build | FanManPro | 8 | 9 |
01-20-2023, 11:45 AM Last Post: _Aka_ |
|