Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Rotation anchors
#1
Photo 
I just bought the latest Curvy and have been trying to get an effect from a flat CG extrusion.  I would like the X-axis of the extrusion to always remain parallel to the X-Z plane. The spline does not stay in this plane but can vary in Y. I wish to prevent the X-axis (side to side of the extrusion) to not bank.

I can not figure out a way to use the Orientation Anchors and / or Spline Orientation mode to make this happen. 

In the image I've included, the CP at the top of the curve should have the orientation vector pointing straight up as an example.

Any suggestions or solutions to make this happen?


Attached Files Thumbnail(s)
   
Reply


Messages In This Thread
Rotation anchors - by tairoark - 05-30-2022, 03:38 AM
RE: Rotation anchors - by _Aka_ - 05-30-2022, 04:52 PM
RE: Rotation anchors - by tairoark - 05-30-2022, 07:05 PM
RE: Rotation anchors - by tairoark - 05-30-2022, 08:07 PM
RE: Rotation anchors - by _Aka_ - 06-01-2022, 02:54 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
Exclamation bad rotation aloriza 5 13 11-29-2023, 09:52 AM
Last Post: _Aka_
  Rotation issue with generator nicolaj.h.andersen@gmail.com 1 14 04-14-2023, 11:58 AM
Last Post: _Aka_
  Align to spline action and rotation Lupp_ 3 1,341 01-23-2021, 08:12 PM
Last Post: _Aka_
  Rotation of Curvy Spline Segment jh092 1 1,350 05-31-2020, 09:36 AM
Last Post: _Aka_

Forum Jump: