Ball jumps on colliders edges
|
Ball jumps on colliders edges
|
04-24-2022, 01:43 PM
Hi
Have you tried to use the Combine option in the Create Mesh module to module one single mesh? Same question about not using the Split option if you are using it.
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Ball jumps on colliders edges - by Dmitrii_Dzh - 04-24-2022, 07:50 AM
RE: Ball jumps on colliders edges - by _Aka_ - 04-24-2022, 01:43 PM
RE: Ball jumps on colliders edges - by Sacryn - 04-25-2022, 09:31 AM
RE: Ball jumps on colliders edges - by _Aka_ - 04-25-2022, 01:17 PM
RE: Ball jumps on colliders edges - by Dmitrii_Dzh - 04-25-2022, 02:38 PM
RE: Ball jumps on colliders edges - by _Aka_ - 04-25-2022, 04:26 PM
RE: Ball jumps on colliders edges - by Dmitrii_Dzh - 04-25-2022, 06:01 PM
RE: Ball jumps on colliders edges - by Sacryn - 04-26-2022, 06:50 AM
RE: Ball jumps on colliders edges - by _Aka_ - 04-26-2022, 02:17 PM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Rough edges on tight corners | migwellian | 5 | 13 |
03-20-2023, 09:48 AM Last Post: migwellian |
|
| Scale Deform Mesh Along Spline? / aligning colliders | MamasToast | 9 | 71 |
10-31-2022, 03:44 AM Last Post: tairoark |
|
| Creating splines from the surface of existing 2d colliders | Monomirror | 2 | 486 |
08-18-2021, 03:55 PM Last Post: Monomirror |
|
| Mesh Lines - Horizontal and Vertical Edges | Krypton | 14 | 4,759 |
09-23-2020, 02:16 AM Last Post: Krypton |
|
