02-25-2022, 10:10 PM
Hi
I have recently bought Curvy for the new mesh deformation capability but I can't seem to be able to control the scale of this mesh using a curve. However, when I use the mesh extrusion feature then this does have the ability to control the scale of the mesh and also has a curve editor that can be used? I am I missing something that is obvious to other more experienced users or is this capability missing or not working?
I tried to perform this in the barbed wire example but all I managed to do was scale just one of the meshes by a uniform and not by a gradual in and out.
I did see another post to do with control point scales which is how other spline system appear to work but the thread suggested I write some extra code to read the metadata? I am not a programmer so I am not really sure about what I should do if I even understood if the issue posted was the same as my question.
Is this something that will be added in a future update?
Sorry to be a pain.
Thank you
I have recently bought Curvy for the new mesh deformation capability but I can't seem to be able to control the scale of this mesh using a curve. However, when I use the mesh extrusion feature then this does have the ability to control the scale of the mesh and also has a curve editor that can be used? I am I missing something that is obvious to other more experienced users or is this capability missing or not working?
I tried to perform this in the barbed wire example but all I managed to do was scale just one of the meshes by a uniform and not by a gradual in and out.
I did see another post to do with control point scales which is how other spline system appear to work but the thread suggested I write some extra code to read the metadata? I am not a programmer so I am not really sure about what I should do if I even understood if the issue posted was the same as my question.
Is this something that will be added in a future update?
Sorry to be a pain.
Thank you