Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Is it possible to generate an output spline after the conform path module?
#4
You are welcome.
Both controllers have the same parameters. One tricky difference is explained here (Position Mode): https://curvyeditor.com/documentation/controllers/start#position_mode
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
Reply


Messages In This Thread
RE: Is it possible to generate an output spline after the conform path module? - by _Aka_ - 03-21-2021, 06:37 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Incorrect mesh alignment after extrusion on curved path Thinkurvy 10 19 04-17-2024, 10:57 AM
Last Post: _Aka_
  Rasterized Path Range issue proton 2 10 04-15-2024, 03:42 PM
Last Post: _Aka_
  Curvy Line Renderer for UI Spline? gekido 3 6 04-04-2024, 12:56 PM
Last Post: _Aka_
  Get position of all control points for a spline gekido 1 6 03-28-2024, 10:08 PM
Last Post: _Aka_

Forum Jump: