06-20-2026, 12:04 PM
You done nothing foolish, don't worry.
Here is a screenshot of two different generators:
The top one is made similarly to yours (using Path Relative Translation module). The bottom one does not use that module, but sets the translation in Volume Spots module -> Group -> Translation -> Translation X (with Relative Translation set to true). The bottom one produces the result you want I believe.
Basically what is happening in your setup is that you generate two different paths, with different lengths, and placing objects in both paths with the same inter-object distance will eventually lead to the right and left objects not being aligned anymore.
With my solution, every left/right object couple is placed at the same position spline wise, but with an additional translation.
Here is a screenshot of two different generators:
The top one is made similarly to yours (using Path Relative Translation module). The bottom one does not use that module, but sets the translation in Volume Spots module -> Group -> Translation -> Translation X (with Relative Translation set to true). The bottom one produces the result you want I believe.
Basically what is happening in your setup is that you generate two different paths, with different lengths, and placing objects in both paths with the same inter-object distance will eventually lead to the right and left objects not being aligned anymore.
With my solution, every left/right object couple is placed at the same position spline wise, but with an additional translation.
Please consider leaving a review for Curvy Splines, this helps immensely. Thank you.
