Toolbuddy Support Forum › Unity Asset Support Forums › Curvy Splines v
SplineController Ignores Follow-Up and Chooses Wrong Spline

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
SplineController Ignores Follow-Up and Chooses Wrong Spline
Josenildo Offline
Junior Member
**
Posts: 12
Threads: 5
Joined: Oct 2019
#1
07-24-2025, 01:54 AM (This post was last modified: 07-24-2025, 01:55 AM by Josenildo.)
Hi, I have a connection between two splines and I’ve set a Follow-Up on that connection point to explicitly define which spline the controller should follow next. However, the
SplineController sometimes follows a different spline that wasn't specified.
The Connection Handling setting is set to:
"Follow-Up, otherwise random"
Why is it not always following the assigned Follow-Up spline?
What could cause the controller to ignore the Follow-Up and go to another connected spline?

(video attached)


Attached Files Thumbnail(s)
   

.mp4   curvy.mp4 (Size: 1.62 MB / Downloads: 3)
Find
Reply


Messages In This Thread
SplineController Ignores Follow-Up and Chooses Wrong Spline - by Josenildo - 07-24-2025, 01:54 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Spline Issue Leading to Unity Freeze Pankaj09 1 370 08-24-2026, 11:28 PM
Last Post: _Aka_
  Connecting Multiple Spline Nodes Issue Ritesh Kadam 1 318 08-22-2026, 11:24 PM
Last Post: _Aka_
  Spline Spots from 2 samples. BitBlit 8 1,432 06-30-2026, 11:49 AM
Last Post: _Aka_
  Best way to duplicate a spline with an offset Kapistijn 8 2,784 04-12-2026, 03:18 PM
Last Post: _Aka_

Forum Jump: