07-11-2024, 12:14 PM
Hi,
Thank you for the reply! My bad, I seem to have misunderstood something regarding the offset radius. I am now using a spline controller, with the offset radius for lateral movement, and custom connection handling for the different paths, and all works well.
Now I am wondering if there is a way to limit lateral movement based on track width, similar to how it works for the volume controller. With the volume controller, if I scale the shape extrusion to start at x width, and then it ends at x/2 width, lateral movement will always be clamped correctly between the edges of this shape. Is it possible to create the track with volumes still, and get the scaled width and use it to limit the offset radius in the spline controller similarily?
Thank you for the reply! My bad, I seem to have misunderstood something regarding the offset radius. I am now using a spline controller, with the offset radius for lateral movement, and custom connection handling for the different paths, and all works well.
Now I am wondering if there is a way to limit lateral movement based on track width, similar to how it works for the volume controller. With the volume controller, if I scale the shape extrusion to start at x width, and then it ends at x/2 width, lateral movement will always be clamped correctly between the edges of this shape. Is it possible to create the track with volumes still, and get the scaled width and use it to limit the offset radius in the spline controller similarily?
