Toolbuddy Support Forum › Unity Asset Support Forums › Curvy Splines v
Changing spline connection in inspector causes splines to revert to defaults

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Changing spline connection in inspector causes splines to revert to defaults
lacota Offline
Junior Member
**
Posts: 6
Threads: 3
Joined: May 2023
#3
03-17-2024, 04:41 PM
Unable to reproduce since I recreated everything. I also saw some strange behaviour when copying splines, with the copies reverting to defaults but haven't seen that with the new instances either so perhaps just a bad state?

Unity: 2022.3.20f1
Curvy: 8.7.3
Find
Reply


Messages In This Thread
RE: Changing spline connection in inspector causes splines to revert to defaults - by lacota - 03-17-2024, 04:41 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Best way to duplicate a spline with an offset Kapistijn 8 1,322 04-12-2026, 03:18 PM
Last Post: _Aka_
Lightbulb Junction & Connection Navigation System Design SAMYTHEBIGJUICY 6 3,442 03-25-2026, 10:10 PM
Last Post: _Aka_
  Connections Between Opposing Splines lockiidraws 1 571 12-04-2025, 02:14 PM
Last Post: _Aka_
Smile Constant speed along a spline? tfishell 1 649 11-13-2025, 11:32 AM
Last Post: _Aka_

Forum Jump: