11-16-2023, 07:44 PM
Hi
The controller continues towards Spline 1.CP003 because it is the next one while moving forwards. If you invert the CPs of spline 1, such as CP0000 is the ones at the left and CP0003 is at the right, then the movement will be like you want it to be.
To flip a spline easily, use the "Flip" tool in the toolbar:
https://curvyeditor.com/documentation/to...start#flip
Otherwise, you can try changing the controller direction when reaching the control point with the connection, using the spline controllers' On Control Point Reached event.
Did this help?
Have a nice day.
The controller continues towards Spline 1.CP003 because it is the next one while moving forwards. If you invert the CPs of spline 1, such as CP0000 is the ones at the left and CP0003 is at the right, then the movement will be like you want it to be.
To flip a spline easily, use the "Flip" tool in the toolbar:
https://curvyeditor.com/documentation/to...start#flip
Otherwise, you can try changing the controller direction when reaching the control point with the connection, using the spline controllers' On Control Point Reached event.
Did this help?
Have a nice day.
Please consider leaving a review for Curvy Splines, this helps immensely. Thank you.
