Connect two spline at runtime

[Doomchecker]

Hi

What you are missing is to set the following properties of your controls points to true:
ConnectionSyncPosition
ConnectionSyncRotation

When you select a preset in the connection inspector, you can see that what it does is to modify the "Sync Position" and "Sync Rotation" values of the connected control points. There are the the properties I listed above.

I hope this helped. Feel free to ask if you need anything else.
If and when you feel like it, please leave a review for the asset, that helps a lot.
Have a nice day

Hi,
thanks for helping out, works perfectly fine!