10-21-2021, 08:09 PM
Hi,
I have what I think is a very simple spline. It has 6 points, and all of them are on the XY plane. None are rotated. However, when using a Spline Controller, at around 0.77 tf, my controlled object flips orientation by 180 deg, and soon flips back at about 0.77 to it's correct orientation.
Any ideas to what would cause this?
Thanks.
I have what I think is a very simple spline. It has 6 points, and all of them are on the XY plane. None are rotated. However, when using a Spline Controller, at around 0.77 tf, my controlled object flips orientation by 180 deg, and soon flips back at about 0.77 to it's correct orientation.
Any ideas to what would cause this?
Thanks.