Toolbuddy Support Forum › Unity Asset Support Forums › Curvy Splines v
Extrusion does not match Controller position

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Extrusion does not match Controller position
_Aka_ Offline
Administrator
*******
Posts: 2,205
Threads: 99
Joined: Jun 2017
#4
05-26-2020, 10:18 PM
You are welcome. This difference between Path Controller an Spline Controller is based on a choice done before my time at Curvy. I kinda get why this choice was done (once you look deep in the code it kinda makes sense), but I still want to get rid of that difference. Right now I am focusing on more important fixes, but maybe some time soon.
Available for freelance work, feel free to reach out: toolbuddy.net
Please consider leaving a review for Curvy, this helps immensely. Thank you.
Find
Reply


Messages In This Thread
RE: Extrusion does not match Controller position - by _Aka_ - 05-26-2020, 10:18 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Is there a way to get the position of each ControlPoint in spline by API? Chanon 1 2,126 06-07-2025, 09:44 AM
Last Post: _Aka_
  Can't set CG Path Controller j95677 4 3,239 10-04-2024, 06:55 PM
Last Post: j95677
  How to use CG Volume Controller j95677 5 3,598 07-17-2024, 07:15 PM
Last Post: j95677
  Incorrect mesh alignment after extrusion on curved path Thinkurvy 10 5,109 04-17-2024, 10:57 AM
Last Post: _Aka_

Forum Jump: