02-14-2020, 11:11 PM
Hi,
You can connect control points only at control points. So in your case, you will have to create a control point at the desired position and then make the connection at that level.
Did this help?
Also, the Shift and Subdivide tools in the toolbar might help in your task
Have a nice day
You can connect control points only at control points. So in your case, you will have to create a control point at the desired position and then make the connection at that level.
Did this help?
Also, the Shift and Subdivide tools in the toolbar might help in your task
Have a nice day
Available for freelance work, feel free to reach out: toolbuddy.net
Please consider leaving a review for Curvy, this helps immensely. Thank you.
Please consider leaving a review for Curvy, this helps immensely. Thank you.
