10-08-2013, 12:55 PM
Hi Jedibald,
thanks for supporting us!
* If you need physics, you're bound to colliders. So you'll need to use the road mesh (generated e.g. by the SplineMeshBuilder) as a mesh collider and rely on physics only.
* If you only want to move left or right (shooter style), the axis to strafe on can be found by using the spline's orientation and tangent (see CurvySplineBase.GetExtrusionPoint). For example, if you're road is 4 units wide, GetExtrusionPoint(myTFPosition, 2, 90) gives you the rightmost point of your road (angle of 270 or better "currentPos-Rightmost" gives you the leftmost point). On Left/Right, just move the car between the leftmost and rightmost position.
Hope that helps
Jake
thanks for supporting us!
(10-08-2013, 12:39 PM)jedibald Wrote: But I'd like to know if there would be a way to use Curvy to make a racer using splines as roads, and so to move freely on it and not being restrained on a line ?There are several ways I can think of. The best way highly depends on your scenario:
* If you need physics, you're bound to colliders. So you'll need to use the road mesh (generated e.g. by the SplineMeshBuilder) as a mesh collider and rely on physics only.
* If you only want to move left or right (shooter style), the axis to strafe on can be found by using the spline's orientation and tangent (see CurvySplineBase.GetExtrusionPoint). For example, if you're road is 4 units wide, GetExtrusionPoint(myTFPosition, 2, 90) gives you the rightmost point of your road (angle of 270 or better "currentPos-Rightmost" gives you the leftmost point). On Left/Right, just move the car between the leftmost and rightmost position.
Hope that helps
Jake
