07-25-2019, 02:08 PM
You don't need follow ups then.
Follow-ups are there to be able to smoothly connect splines whose geometry depends on more than the adjacent CPs. More about the subject here:
https://curvyeditor.com/documentation/sp...#follow-up
In your case, just connect the CPs, with no follow ups setting, and then go to the spline controller, "Connection handling" section, and set it to "Random Spline" with "Reject current spline" set to true. Since you connect only two splines, selecting a random spline other than the current one will automatically select the other spline.
Did it work?
Follow-ups are there to be able to smoothly connect splines whose geometry depends on more than the adjacent CPs. More about the subject here:
https://curvyeditor.com/documentation/sp...#follow-up
In your case, just connect the CPs, with no follow ups setting, and then go to the spline controller, "Connection handling" section, and set it to "Random Spline" with "Reject current spline" set to true. Since you connect only two splines, selecting a random spline other than the current one will automatically select the other spline.
Did it work?
Please consider leaving a review for Curvy Splines, this helps immensely. Thank you.
