|
Spline Path Extrusion
|
12-26-2017, 06:02 AM
I realize that curvy extrudes meshes along the length of the path, but I want to create a cliff face with an overhang. So on each sides of the cliff I would have two paths, and want to know if Curvy can figure out mesh by morphing one path into the other. If not, I can write it myself, if there is some support of that, just seeing if that exists already and I'm not seeing it.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Spline Path Extrusion - by Elenesski - 12-26-2017, 01:25 AM
RE: Spline Path Extrusion - by Elenesski - 12-26-2017, 06:02 AM
RE: Spline Path Extrusion - by _Aka_ - 01-12-2018, 06:07 PM
RE: Spline Path Extrusion - by Elenesski - 01-17-2018, 02:45 AM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Best way to duplicate a spline with an offset | Kapistijn | 8 | 1,349 |
04-12-2026, 03:18 PM Last Post: _Aka_ |
|
|
Constant speed along a spline? | tfishell | 1 | 654 |
11-13-2025, 11:32 AM Last Post: _Aka_ |
| SplineController Ignores Follow-Up and Chooses Wrong Spline | Josenildo | 7 | 4,452 |
07-29-2025, 09:15 PM Last Post: _Aka_ |
|
| Curvy Line Renderer for UI Spline? | gekido | 7 | 6,203 |
07-13-2025, 07:11 PM Last Post: _Aka_ |
|
