01-06-2016, 03:05 AM
The vertical support beams have rotation mode set to "horizontal" in the volume spots panel. The wooden planks have the rotation mode set to "full". Is there a way to have objects set to horizontal rotation, but have their height align with the tilted spline at their offset?
Here is another attachment with the horizontal beam turned off. The vertical beam on the left needs its height set a little lower while the beam on the right needs its height set a little higher.
Here is another attachment with the horizontal beam turned off. The vertical beam on the left needs its height set a little lower while the beam on the right needs its height set a little higher.