Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Efficiently chopping up a build extrusion?
#1
I'm creating a scene with a vehicle that remains stationary, and lane lines will move towards the vehicle as the vehicle's speed increases.

I'm trying to create moving lane lines using a generator for each lane line, then set the path spline for all of them to be the same and change their position based on the speed of the vehicle on every update message.

I'll have about 50~ generators in my scene, 1 for each lane line. I've configured the resolution and angle threshold optimization to be optimal for performance vs esthetic. 

Not unexpectedly, this is quite a performance intensive, is there a more efficient way to do this with CurvySplines?

Thanks!
Reply
#2
Solved!!

Discovered that changing the UV offset was significantly more efficient.
Reply
#3
Glad that you found a solution.
Have a nice day
Please consider leaving a review for Curvy. This will help a lot keeping Curvy relevant in the eyes of the Asset Store algorithm.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Fading in/out extrusion mesh of a spline? _RicO 3 5 07-25-2023, 09:40 PM
Last Post: _Aka_
  Invisible generated meshes in build itsGama 5 10 06-08-2023, 11:53 AM
Last Post: _Aka_
  Missing Loader errors after build FanManPro 8 9 01-20-2023, 11:45 AM
Last Post: _Aka_
  Connection extrusion briceio 1 13 08-04-2022, 12:36 PM
Last Post: _Aka_

Forum Jump: