Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Can't connect more than 2 spline nodes at a time
#1
I have multiple splines and I'm trying to connect all of their root nodes (the idea is that the user can traverse several distinct paths from a single starting point). However, after connecting two nodes, the 'Connect Spline' button is greyed out when I select either node and a third, unlinked node. In fact, I can't seem to connect a third spline to any node of the two connect splines. Is this a limitation of the script, or am I missing something? 
Reply
#2
The selection order matters. If you have two splines A and B you want to connect to C:
  • Select an end CP of A and the target CP of C afterwards (hold CTRL to select both CPs), then click on "Connect"
  • Select an end CP of B and the tgarget CP of C (can be the same as above), then click on "Connect"
Note that the source CPs (the CPs of A and B) needs to be the start or end CPs! Btw, this limitation will go with the next version.
 
Reply
#3
Aha, that did it! Thanks for the help Smile
This is a really tremendous plugin btw, exactly what I needed and then some.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Curvy Line Renderer for UI Spline? gekido 1 1 4 hours ago
Last Post: _Aka_
  Get position of all control points for a spline gekido 1 2 4 hours ago
Last Post: _Aka_
Bug Changing spline connection in inspector causes splines to revert to defaults lacota 3 6 03-18-2024, 07:55 PM
Last Post: _Aka_
  GO can't fit end of the spline GameDeveloperek4123 3 13 03-04-2024, 11:06 AM
Last Post: _Aka_

Forum Jump: